Raising ZR5 nerf bars

Cajun · Post by **Cajun** » Fri Feb 10, 2006 10:03 am

Has anyone raised their stock ZR5 nerf bars? If so, I'd like to know how you went about it. They look rather silly sitting so low and visual ground the truck.

Craig

Post by **Walt** » Fri Feb 10, 2006 1:35 pm

Cajun, I found one thread that has some good info in it from Top and Brule.

http://www.s-10crewcab.com/phpBB2/viewt ... ht=raising

Also, go here for pics:
http://www.s-10crewcab.com/coppermine/i ... ?cat=10099

Hope this helps

Cajun · Post by **Cajun** » Fri Feb 10, 2006 2:00 pm

Perfect! Just what I needed. Thanks Mason!

Post by **Walt** » Fri Feb 10, 2006 2:39 pm

Actually it's Walt

Amason is my last name

top_sgt · Post by **top_sgt** » Fri Feb 10, 2006 3:48 pm

cajun....look at my pics noted above!!!! i just measured down 2 inches and drilled new holes. i did drill holes for the parking brake cable to pass thru the brackets on the drivers side....... i think i used a 1/2 inch bit for those. if you have any questions let me know!!!!!!!!