Won't start *solved (bad starter)

kenfyoozed · Post by **kenfyoozed** » Thu Mar 15, 2012 7:59 am

2003 s10 CC 4wd 4.3l, been having problems not wanting to start now it won't start at all. Only code I get is a u1041, other codes I had were for an air sensor and O2 sensor. I've done some searching and will make sure the ground to the ebcm is good at g110. Any thing else I can check before I haul this off to the dealership.

Post by **HenryJ** » Thu Mar 15, 2012 10:36 am

Check the basics. Ignition (plugs, cap, rotor) , fuel ( pressure, filter )

roadrunner · Post by **roadrunner** » Thu Mar 15, 2012 3:35 pm

U1041???? Haven't heard of that one before. My manual lists B, C, and P codes but no U codes. The last time I had a no start condition with my cc it was cap/rotor problem. They were near new but obviously shorting out cylinder to cylinder as the engine acted like the cap was wet and cross-firing. Replaced both with AC Delco and no problems since.

kenfyoozed · Post by **kenfyoozed** » Thu Mar 15, 2012 5:54 pm

Thanks HJ, i did as you suggested and now find that my starter is no good. Rap on it while the key is turned, she fires over. so now i know what it is. Thanks.

Post by **HenryJ** » Thu Mar 15, 2012 5:56 pm

Glad you found it.

S-10CREWCAB.NET

Won't start *solved (bad starter)

Won't start *solved (bad starter)

Re: Won't start u1041

Re: Won't start u1041

Re: Won't start u1041

Re: Won't start u1041