I am taking off my throttle body to change the throttle blade & clean it. But I can't get the
cruise cable off, the GM-SI manual says not to remove the "C" clip or unscrew the adjuster, just use a flat blade screwdriver to pry it off, but if I pry too hard, I'm afraid it'll break. Is there a better way, or should I not worry about breaking it.
R & R cruise control cable
Moderator: F9K9
R & R cruise control cable
'03 S-10 ext. cab 4.3, truck top, CAI intake, reprogrammed PCM, Throttle blade mod., e-fans, 180* thermo., Flowmaster 50, Clear corner & tailgate lighls, LED's all around, Camaro RS/Z28 wheels, Sony HU, Sony Spkrs. in doors, small amp. & Sub., converted to power windows, bucket seats & floor console, big 3 mod, AD 244 alt.
-
green02crew
- Crew Elite
- Posts: 863
- Joined: Mon Nov 12, 2007 7:56 pm
- Location: Northern NH
- Contact:
Re: R & R cruise control cable
I didn't take the throttle body off. It can be removed without full disassembly.
2002 S-10 Crew Cab
Too Many Mods Check the Readers Rides Page
Too Many Mods Check the Readers Rides Page
Re: R & R cruise control cable
I know, but after that @%&# cruise cable, and the throttle cable it's only 5 bolts, and then I can clean it real good & change the throttle blade without dropping anything down the intake (including a bunch of carb. cleaner & carbon). That's agreen02crew wrote:I didn't take the throttle body off. It can be removed without full disassembly.
And I tend to be a clutz.'03 S-10 ext. cab 4.3, truck top, CAI intake, reprogrammed PCM, Throttle blade mod., e-fans, 180* thermo., Flowmaster 50, Clear corner & tailgate lighls, LED's all around, Camaro RS/Z28 wheels, Sony HU, Sony Spkrs. in doors, small amp. & Sub., converted to power windows, bucket seats & floor console, big 3 mod, AD 244 alt.