Winch Question
Posted: Tue Mar 02, 2010 8:03 am
Its on a Honda Foreman ATV. 3k lb Warn winch. The winch goes in fine but as soon as the out button is pressed, it pops a fuse (15amp). My dad suggested there could be moisture in the winch and to run it in, freespool out, then run in again and get it warmed up to see if that helps. I didn't think it would do much but worth a shot, still blows fuses. I would think its grounding out somewhere, any thoughts?
It went in and out fine when lifting the plow blade, then it went in and would not come back out.
***Update: Apparently the winch control box has a recall from Warn due to possibly fire issue due to heating up, so after signing up for that recall notice, a free one is on its way. That will limit it to either a wire short, winch motor issue or switch failure. One of 4 possibilities replaced for free!
http://www.warn.com/atv/recall_notice.shtml
It went in and out fine when lifting the plow blade, then it went in and would not come back out.
***Update: Apparently the winch control box has a recall from Warn due to possibly fire issue due to heating up, so after signing up for that recall notice, a free one is on its way. That will limit it to either a wire short, winch motor issue or switch failure. One of 4 possibilities replaced for free!
http://www.warn.com/atv/recall_notice.shtml
