Measurements for Boise Springworks Kit?

CGRob · Post by **CGRob** » Sat Apr 16, 2016 5:15 am

Hey Gang,

I have a very capable spring shop in my area and would like to look into having them fab a rear lift spring set up like the BSW kit. A while back I found a post somewhere that had the dimensions of each of the leaves in the BSW spring pack, and thought I book marked it, but now I cant seem to find it. I've searched and searched and no dice.

This post had all of the info I needed to take to the local shop to have the springs made. Does anyone remember the post I'm looking for and know where I can find it?

Thanks in advance!

-Rob

Post by **HenryJ** » Sat Apr 16, 2016 6:19 am

From the modifications page linked to the logo up top: Boise Springworks kit

I don't think it has exact dimensions, but if you show it to your spring shop they should be capable of building the kit

CGRob · Post by **CGRob** » Sun Apr 17, 2016 4:08 am

Thanks for the info Brule!

I found that article, however the one I was looking for had actual dimensions and hole position of each leaf listed. upon further investigation, I realized that I found the info on Pirate4X4.com. I was thinking the article was here because it was written by our very own Stucky. Anyway, I will post that info below in case anyone is interested.

Boise Springworks S10 kit $230
Phone: 208-377-1157
Boise Spring Works
Kit includes 6 springs, 4 u bolts with nuts and washers, and 2 3/8" center bolts with nuts
Long leaf length: 25 inches (13/12 with short side forward)
Middle leaf length: 19 inches (10/9 with short side forward)
Short leaf length: 12 inches (6/6 centered pin)

-Rob

Post by **HenryJ** » Sun Apr 17, 2016 7:12 am

Cool, thank you. I will add it to that page

_STUCKY · Post by **_STUCKY** » Tue Apr 19, 2016 4:38 am

Whoopsy!

Not sure why I posted it there and not here, but I'm glad you found it. I'd have to look for them, but I'm not running all 3 springs anymore. I'm now soa, pretty sure I have the longest from the kit still in the truck. I'll measure the arch on them when I get a chance.

_STUCKY · Post by **_STUCKY** » Thu Jun 16, 2016 5:50 am

I just realized I never followed up with measurements.... You still need them?

CGRob · Post by **CGRob** » Sat Jul 02, 2016 2:49 am

Yes sir, that would be great. Looking to have the leaf springs fabbed shortly. Thanks!!

-Rob

S-10CREWCAB.NET

Measurements for Boise Springworks Kit?

Measurements for Boise Springworks Kit?

Re: Measurements for Boise Springworks Kit?

Re: Measurements for Boise Springworks Kit?

Re: Measurements for Boise Springworks Kit?

Re: Measurements for Boise Springworks Kit?