Front Axle Noise
Moderator: F9K9
Front Axle Noise
I have started hearing some new sounds from my front axle. I just replaced the Tansfer Case Vacuum Switch and Front Axle Actuator. Now Then I am in 4x2 there is a noise comming from the front end and it goes away when in 4x4. The Noise starts at 45mph. Any Ideas what this could before I pull it all apart to replace my Oil Pan gasket and rear main seal?
- F9K9
- Mod K Elite
- Posts: 6183
- Joined: Sun May 30, 2004 12:26 pm
- Location: London, Kentucky, United States
Then it just might be the bearing assembly. Jack it up and grab it at the 12 + 6 O'clock position. If, it has play then replace it.hunter401 wrote:It sounds like a hub bearing...........
[size=75][b]"For those who have fought for it, [i][color=red]FR[/color][color=white]EE[/color][color=blue]DOM[/color][/i] has a taste that the protected will never know."
[url=http://www.naxja.org/forum/showthread.php?t=73349]GUIDE TO SEARCHING. [i] (Some of the forum software is different but, it has helped me a lot.)[/i][/url][/b]
[b]"Those who don't know history are destined to repeat it." Edmund Burke[/b][/size]
[url=http://www.naxja.org/forum/showthread.php?t=73349]GUIDE TO SEARCHING. [i] (Some of the forum software is different but, it has helped me a lot.)[/i][/url][/b]
[b]"Those who don't know history are destined to repeat it." Edmund Burke[/b][/size]
- F9K9
- Mod K Elite
- Posts: 6183
- Joined: Sun May 30, 2004 12:26 pm
- Location: London, Kentucky, United States
Did you replace both assemblies? I recently got fooled on a heep. I swore up and down it was the right side making the noise. The noise didn't stop until I replaced the left one as well.
[size=75][b]"For those who have fought for it, [i][color=red]FR[/color][color=white]EE[/color][color=blue]DOM[/color][/i] has a taste that the protected will never know."
[url=http://www.naxja.org/forum/showthread.php?t=73349]GUIDE TO SEARCHING. [i] (Some of the forum software is different but, it has helped me a lot.)[/i][/url][/b]
[b]"Those who don't know history are destined to repeat it." Edmund Burke[/b][/size]
[url=http://www.naxja.org/forum/showthread.php?t=73349]GUIDE TO SEARCHING. [i] (Some of the forum software is different but, it has helped me a lot.)[/i][/url][/b]
[b]"Those who don't know history are destined to repeat it." Edmund Burke[/b][/size]
Your front axle may be staying engaged even though your transfer case is not.
With you truck running and the transfer case in 2wd, block the wheels and try turning the front driveshaft. It should turn with very little resistance.
Just a guess.
James
With you truck running and the transfer case in 2wd, block the wheels and try turning the front driveshaft. It should turn with very little resistance.
Just a guess.
James
2001 S10 Crew (wife's mail truck)
2002 S10 Crew, 2003 S10 Blazer
2006 K2500 5 speed
2002 S10 Crew, 2003 S10 Blazer
2006 K2500 5 speed
-
- Crew
- Posts: 95
- Joined: Sun Jul 19, 2009 1:54 pm
- Location: East Grand Forks, Minnesota