There was some question as to how to remove the little panel without breaking it.
The panel just snaps in , a small screwdriver slipped underneath should pop it loose.
Here's a picture of my old panel , please excuse the butcher job, I have since gone to using a wiper/hatch release switch for all the functions I need to control now.
There is a pin centered between the two retention prongs on one end, and a raised bar on the other end to prevent it being installed upside down.
"Speed doesn't kill, suddenly becoming stationary does." - Richard Hammond
"Speed is just a matter of Money - How fast do YOU want to go?"-Mechanic from Mad Max-
If at first you don't succeed - Don't take up Skydiving! - ThunderIIKE7CSK
Do the Crew Cabs have the wiring harness behind the blank panel for the air bag switch? I would like to put the switch from a regular S10 into my Crew Cab so I can turn off the air bag for my 9 year old daughter. Thanks, Steve
killian96ss wrote:Do the Crew Cabs have the wiring harness behind the blank panel for the air bag switch? I would like to put the switch from a regular S10 into my Crew Cab so I can turn off the air bag for my 9 year old daughter. Thanks, Steve
It might have it, but I doubt it will, as they try to save a penny whereever they can. If it has the harness though, it would be a simple plug and play thing.
Just keep in mind children under 70lbs or 4' should always sit in the back seat whenever possible.
Last edited by Dragonmaster on Mon Nov 24, 2003 1:32 pm, edited 1 time in total.
[size=75]1 of 6 Wheatland Yellow Sonoma's in Canada
LOL Yeah -- but have your windows rolled down a little though -- when the airbags went off in my Z24 it blew both windows out of track, and blew my sunroof out of it's track too.
[size=75]Thanks, CHRIS
2000 S10 Blazer 4x4 4Dr. -- 2" PA BodyLift, Daystar Shackles, TB Crank, 1.75" Rear wheel spacers, Yakima roofrack, 30" BFG AT's.
1969 VW Bug -- airbagged and in pieces.
1962 VW Karmann ghia -- rusting over in the corner. "That's not a tool--that's a damn brick!"[/size]
killian96ss wrote:Do the Crew Cabs have the wiring harness behind the blank panel for the air bag switch? I would like to put the switch from a regular S10 into my Crew Cab so I can turn off the air bag for my 9 year old daughter. Thanks, Steve
On my '03, it looks like the wiring is there. Basically there are wires there but I am not sure what they do. I have always wondered what they were for.
Dave
It should be a harness with six wires, if that's what you have, it should work. It may require a quick reprogram of the BCM, but there is no harm in trying it, as the signal for them to open is sent by a computer, not the switch.
Discalimer: If you mess up your airbags (SIR system), have them go off, or anything goes wrong with your truck it's not my fault.
[/b]
[size=75]1 of 6 Wheatland Yellow Sonoma's in Canada
killian96ss wrote:Do the Crew Cabs have the wiring harness behind the blank panel for the air bag switch?
No, we have the same harness as all the utilities (Blazers) , so the wiring for the rear wiper/hatch release is back there.
"Speed doesn't kill, suddenly becoming stationary does." - Richard Hammond
"Speed is just a matter of Money - How fast do YOU want to go?"-Mechanic from Mad Max-
If at first you don't succeed - Don't take up Skydiving! - ThunderIIKE7CSK
[size=75]Thanks, CHRIS
2000 S10 Blazer 4x4 4Dr. -- 2" PA BodyLift, Daystar Shackles, TB Crank, 1.75" Rear wheel spacers, Yakima roofrack, 30" BFG AT's.
1969 VW Bug -- airbagged and in pieces.
1962 VW Karmann ghia -- rusting over in the corner. "That's not a tool--that's a damn brick!"[/size]
melloyellow wrote:I am going to measure the voltages on the harness. I am looking for a 12V accessory link for my iPod. Then I won't need the lighter.
How about the pin assignments and color codes:
HenryJ wrote:
The factory fog light switch is below the dome light switch below the light switch,
That blank panel , to the left of the radio, is the panel for the rear wiper and hatch release. We have the same wiring harness as all the utilities (Blazers).
On the pickup wiring harness the airbag disconnect switch/wiring is there.
Can you use the wiring? YES! I even used the switch
(I've added a couple indicator LEDs since this picture)
Heres the wiring:
Pin A YEL = Accesory Voltage
Pin B DK GRN = Rear Window washer Control
Pin C GRY = Rear Window Wiper Switch Signal
Pin D BLK = Trunk Release Switch Signal
Pin E BLK = Ground
Pin F GRY Instrument Panel Lamp Fuse Supply Voltage
"Speed doesn't kill, suddenly becoming stationary does." - Richard Hammond
"Speed is just a matter of Money - How fast do YOU want to go?"-Mechanic from Mad Max-
If at first you don't succeed - Don't take up Skydiving! - ThunderIIKE7CSK