S-10CREWCAB.NET

I put a 98 GMC Envoy console into my 03 ZR2. Here is the info you need.DIC (driver info center) plug Pin… #7… dark green… to pin #B2 [blue plug of radio] 2nd from left Pin..; #8… black/white… to pin A12 [gray plug ] or ground Pin… #9… dark green/white…. To rear instrument panel speedo plug A4 [ dark...

Just to keep the info simple without a lot of reading. The VSS wire is connected to the green wire [back of speedo plug] .Info thanks to Henry J. The temperature sensor wire is easiest to get into the cab thru aerial grommet on passenger side floor.

First I would like to commend you for getting the COMPLETE harness out ! It was freezing when I tried to get it out of a 98 Envoy. I have an 03 s10. I ended up cutting the wires. Now I need ONE wire left to hook up! The speedo cluster apparently has a VSS connection. I don,t know what this cluster ...

Who gave you that advise? Wouldn't it be better to ask them? Please keep all this in the same thread. Starting a new thread each time confuses anyone trying to help you sort this out. Did you try my suggestion on ZR2USA to connect to the BCM? The BCM C2 connector (LT BLU) Top numbered A1-A12, botto...

I am installing a long 1998 GMC Envoy overhead console in my 03 S10 and have one wire left to connect . The dreaded VSS wire! I was told it can be got to behind the instrument cluster.Please guide me to it EXACTLY [what color.location etc.]. Please be precise ! Here is a link..Page 28 https://docs.g...

First I would like to commend you for getting the COMPLETE harness out ! It was freezing when I tried to get it out of a 98 Envoy. I have an 03 s10. I ended up cutting the wires. Now I need ONE wire left to hook up! The speedo cluster apparently has a VSS connection. I don,t know what this cluster l...

I presume you are looking for injector #4 control circuit? That's what it is listed as in the 01 manual. If so it is located 4th from the right top row blue connector as viewed in your picture. #4 pin in the other connector as viewed in your pic is not used. As stated in the 01 OEM manual. The wire...

Here are my computer plugs. Top blue.. bottom green.Which is connector #4? Is it blue or green? Left or right? Pin #4 is it starting from left or right?

I have the dash apart on my 03 and have taken out the 3 screws from the sides of the radio. It comes out about an inch and a half and stops . Am I not pulling hard enough or what else is there holding it?

HenryJ wrote:Through the C209 connector at the upper left under the dash by the A pillar.

It is already there on the utility body style harness.

What does this look like or where is it exactly ? Is it the big bunch of wires ? Do I have to make a hole or just push it thru ?

How does the wire from the temperature sensor for an overhead console get into the cab ?

Thank you for your help!

I bought a 98 long ohc from a GMC Envoy and would like to test it to see if it works. Can someone walk me thru the procedure?