looking for tow haul button

[paperboy326]

This has been the only place that I can find the small dash mount tow/haul button being talked about. I would like to get my hands on one of those buttons. Were doing a LS swap into a CJ7 and want to use a tow haul button for momentary switch just to send ground signal to the computer. And idea a part number or where to find one? Thanks.

[HenryJ]

Mine came out of a Bravada probably 1999-2004?

[paperboy326]

Thanks!

[HenryJ]

In case you did not see it: Tow/Haul mod page

[_STUCKY]

Will just any momentary switch work? If so, just google momentary switch. I found some from 12voltguy.com with a pigtail for like 6$ or I think the same button without a pig tail for I think 1$ form partsexpress.com

[HenryJ]

Pretty sure he is looking for the factory look with the markings

[booth9c1ss]

So I'm revisiting this years later (I'm StevenTruck). I recently got a GMC Sonoma Highrider and I'd love to install this option. For a switch, I just used the column shift lever from a 02 full size truck (plug-n-play). I tried one from a AstroVan and that one actually matches better, but you will have to grind the flat key-way to get it to fit. Conveniently, this is also a good way/time to replace that torn rubber boot that most of us have.

Anyways, My truck doesn't have that nice 7-way plug at the front of the floor console. I am willing to plug my wire into the BCM, but I can't find anything about where it plugs in (I know where the BCM is, I just don't know which connector/pin), and that wasn't in the writeup that was done. Could one of you trace back your light blue wire and tell me where it goes into the BCM? Thanks.

Steve

[LoneWolf04]

Looks like C1 of the BCM location B12.

[LoneWolf04]

Once you install the BCM out of the donor blazer you will need to do a theft deterrent relearn with the key cycle operation to get the vehicle started again. Even after that, you will have an airbag light on with a B1001 mismatch code set by the BCM or SDM, I can't remember which. You will have to take it to the dealer to have the theft deterrent relearned with TIS2Web application the dealer uses. The process takes only takes roughly 10 minutes. Will take the guys longer to gather the tech2 passthrough cords and hook it up to the computer more than likely. Shouldn't be charged more than 1/2 hour labor realistically. What the theft deterrent relearn does in the background when relearning the BCM, it also sends the BCM VIN number to the SDM so the mismatch will go away.