S-10CREWCAB.NET

HCO4x4

No I didn't put it back on but I did put a cat back on and my mpg is STILL the same

HCO4x4

The one I made brought my mpg from 13 to 15 but i took it out and cut off the pre-cat and my mpg went to 16-17. So i guess it worked. Not really as much as i wanted but it was an improvement. Mine was small too, I bet the big one above works really well.

HCO4x4

I removed my actual cat a long time ago and now I want to put one back on. Will any cat work in reducing emissions or will it still throw a code if I put the wrong one on?

HCO4x4

Just installed the new actuator and I've got the same problem as before. The cable seems to be a bit too long and the actuator can't seem to pull it all the way in. I have to give a little push to pull it all the way in but the diff. still will not engage. Ideas?

HCO4x4

Got mine at Autozone. So far so good.

HCO4x4

I don't think the honeycomb can be broken that easily...I tried to do that after I cut it all off and couldn't crush it.

HCO4x4

how ugly

HCO4x4

I cant imagine getting that gas mileage lol. Ill try some of your other suggestions. My fuel pump is only 5 months old though.

HCO4x4

Well I took the pre-cat out today... it looked clean to me. I guess the clamps i put on to hold the new pipe aren't air tight because it sounds like a POS. I'll have to fix that and see if my mileage is any better but what else could cause such poor mileage?

HCO4x4

Ok I'll take a look at the precat asap. Thanks for the help

HCO4x4

3.73 gear ratio

HCO4x4

No I didn't but now it makes a lot more sense. Stock gears. Strait flat Florida roads. Know how much a calibration would cost?

HCO4x4

How can you get around 16 mpg and I'm sitting here at 12?

HCO4x4

Problem solved. There is i guess a solenoid where the positive cables go to, under the battery tray. One nut was loose half a turn. Tightened it up and everything's fine.

HCO4x4

Mine died today on my way to school. If the ignition switch is bad would i get power to any fuses?

HCO4x4

I actually was kind of hard on the gas with that tank but your correct. Ill repost when I get definite data.

HCO4x4

Today I replaced the wiring with a thicker gauge. I drove about 10 miles to the gas station with my hydrogen cell on. My tank was about half full but when I calculated my mpg I saw improvement. Even using the hydrogen the little bit I did (10 miles out of 107), ampg went from 12.5 to 13. The only ne...

HCO4x4

One of the automotive teachers at my school made one and hes getting an extra 7 mpg. I haven't yet looked at his but I'm going to try soon. I didn't get a chance to fully replace the wires today but tomorrow I'll get that done and update this page. Oh, and I know its producing the hydrogen because I...

HCO4x4

I made one this past month and it works pretty well. i wired it into my truck today but fried all the wires so i can't tell about gains yet. Have any of you read about or tried to create one of these?

HCO4x4

Sweet truck. I went to the Okeechobee mudfest this past weekend and i saw about 5 s10's 3-4 foot higher than this one! Look up the even on youtube. Its a lot of fun!

HCO4x4

My upper control arm bushings were doing that. I replaced them and haven't heard a creak since.

HCO4x4

Has anyone seen or tried one of these?

O2 Sensor Simulator on Ebay

HCO4x4

I had bad stains on my truck and windows from our well water. Mothers wax did a great job taking it off the paint but didn't do as well on the windows. So i used a dab of toilet bowl cleaner.

They look brand new

HCO4x4

Oh ok. Just wondering because i wanted to take a similar pioneer head unit out of our Escalade and put it in my truck. It wouldnt fit though so i had to go with the flip up one.

Looks cool by the way!

HCO4x4

Isn't that a 2 din?

HCO4x4

I had this problem before and i forget if it went away by itself or when i got an alignment but its back now. I think it could be one of the brakes is hitting harder than the other or possibly something to do with my torsion bars.

HCO4x4

Thank you

HCO4x4

Ok thanks. I've found a cable but its called the control cable. Is that the one I want? Does anyone know where I can get the correct one?

HCO4x4

I didn't see one on synergy, Ebay or Google. Know where I can get one? Also, what is the difference between this cable and the Posi Lock cable besides manual engagement?

HCO4x4

OK thanks for the reply. I guess I'm off to buy a new cable.

HCO4x4

I've got it all back together now and still cannot get the diff to engage without pulling the cable by hand. The actuator is clearly working. There has to be a way the tighten the cable.

HCO4x4

i drained the diff, took the 3 bolts out holding on where the cable enters, I've come to the conclusion that i can lock the diff in if i pull the cable by hand. Is there some type of adjustment like on a brake cable of a bike? There is something that looks like it to me but I guess that is just to h...

HCO4x4

Should i take it apart and look around or take it to a shop?

HCO4x4

My 4wd isnt working once again. The front diff is not engaging. I read something about a collar to lock in the axel and im going to check lube tomorrow. Suggestions?

HCO4x4

Same thing happened to me. Noise when moving but not when the brakes were applied. My caliper bolts werent tightened

HCO4x4

Woo. OK well thanks for the help guys. Guess I'll have to wait.

HCO4x4

Well I have 31's now and my friend is going to be upgrading from 33's to 35's pretty soon so i dont think wheels are a big problem. How goofy do you think the 31's would look anyway? The reason I want to do this now is because I'm on summer break for 2 months and i wont have time to do it during the...

HCO4x4

My truck is a daily driver. I have seen the mystery lift before and i have it all besides the Boise Springs. Right now the truck is perfectly level and I dont really want the rear to be higher and not the front. I think if i can find the superlift for 1200 again I can do it myself as i do everything...

HCO4x4

I want it pretty much for looks. Maybe once a month i hit a nearby mudhole and i go pretty hard. I considered the SAS but i dont feel like i know enough mechanics to do that. Plus I didnt think 1200 would be enough for it. I didnt see any real price for a full SFA kit. I do think that a SAS would be...

HCO4x4

im looking for the 6" superlift and i only have 1200 to spend. I once saw it on ebay for 1200 but now there isnt one. Anyone know where i can get it?

HCO4x4

Well i was side swiped in the left rear and it wasnt that hard plus i offroad pretty hard so i dont think it was from the accident. And thanks for the instructions. The pictures arent there anymore though. Ill jack up the truck tomorrow and see what i can do.

HCO4x4

When i got my truck fixed after an accident the shop told me the motor mounts are broken and i need to replace them. I've looked a few time and cant see the mounts. Could someone take a picture for me? and how easy are they to replace?

HCO4x4

the lucas cleaner in the clear bottle does pretty good for my truck, better milage too.

HCO4x4

oh i see. i suppose it is a waste of time. thanks for talking me out of it lol.

HCO4x4

are the perches absolutely necessary or will the u bolts hold enough? and i realize itll lift it a LOT but i guess i just want to see what it looks like lol.

HCO4x4

I was thinking about how much money i dont have for the boise lift. has anyone done a leaf over on our trucks before? i think im going to do it tomorrow just to see what it looks like. any thoughts?

HCO4x4

no, they are awsome in the mud, just not in sand because they try to dig. and they arent loud going down the road. they hum but not loud. sounds good.

HCO4x4

i have mt's in florida. they arent very good in anythign but mud. not too much traction on pavement, burn outs are easy, but they do ride great. not so great in sand/ dirt. i work on construction sites and buried my truck pullin my trailer through some sand. i'd go with some all terrainsif i were yo...

HCO4x4

does this effect gas milage at all?

HCO4x4

f9k9 wrote:Once I lifted the CC at the LCA and placed a jack stand underneath it, the boot slid right back on.

i was thinking that could work easier, and if not i will use a hose clamp. thanks

HCO4x4

steaking of axle boots, my drivers side boot popped off and i tried to get it back on but i cant get it on all the way. is there a special way to do it or am i just being a wuss.

HCO4x4

i got another autozone pump the other day because they couldnt do refunds without a manager and i need my truck. it runs now but this time it isnt getting as much fuel as it should. my 5th pump and this is the first time its done this new. what is the chance it could be the regulator?

HCO4x4

sweet thanks again

HCO4x4

i took the battery and tray out then i put the truck in the air started it, put it in drive, and also 4 wheel drive. the front driveshaft spun but not the front wheels. i had my dad step on the brake while i pulled the cable out because i saw the actuator struggling. as soon as i pulled it out, my f...

HCO4x4

in drive both back wheels spin and the front driveshaft spins but the front wheels do nothing. i can spin them freely in 2 or 4wd. i hear something like a quiet binding front the front but only if i put my head close to the wheel well.

HCO4x4

thank you for narrowing it down a little more, and ill have to see for sure if the axle is engaging. will post tomorrow.

HCO4x4

i feel the truck jerk when i put it in 4lo. could it still be the vaccume actuator?

HCO4x4

the lights work fine. just as they should. it saounds like the front axle is engaging. but not even one front wheel is helping

HCO4x4

My 4wd feels and sounds like its locking in but when i get stuck i dosnt help at all. the wheels dont even try to crawl. any ideas?

HCO4x4

yea. ok well i guess ill have to return it and grab a delco. thanks

HCO4x4

thats what i hear. but if all autozone pumps go out in 1 month how can they sell them?

HCO4x4

i have been having the exact same problem! it is the fuel pump but every month it does this. im on my fourth pump since christmas and its getting old. the guy at the parts store said it could be the regulator but i replaced it and it actually ran a whole lot worse so i took it out. anyone? i also ha...

HCO4x4

I installed 4 gabriel shocks in my uncles f250 today and i have to say they are some nice shocks. as far as quality, performance they are right up there with bilstein. they look a lot better too. anyone have a say about them? in a lineup where would you rank them?

HCO4x4

HenryJ wrote:Isolate your front bumper and turn it into your antenna.

i like that idea too lol

HCO4x4

anyone found a way to cheat the code yet? i found a thing to wire into your system and it keeps the sensor from throwing the code. does anyone have a simulator they dont want?

HCO4x4

i never thought of it but thats a good idea. it would look a whole lot better than the huge antenna too. i havent looked though. is there room underneath?

HCO4x4

now i feel like an idiot. back when the buttons werent working i blew a fuse. so i swaped it with the 4wd fuse. then i bought new buttons and i was sad to see that my 4wd didnt work. so last week my security system wasnt working and i thought maybe a fuse. i saw that i still had that bad 4wd fuse an...

HCO4x4

done. peice of cake. i dont know y they would charge so much for that.

HCO4x4

lol the bottom left corner is bent up a little. but i realized that was from when i took it off and it hit the ground.

good eye

HCO4x4

Maximous wrote: i told the Service Manager the next time he heard from me i would be sitting on the side of the rode calling asking him if a black truck is supposed to be covered in orange flames, cuz once it starts smoking im not stopping until its on fire or the tranny blows!!!!

thanks great

HCO4x4

no just the straps. my tailgate dosent have any damage but the letter says they have to replace it if you have damage.

HCO4x4

was it hard? i got the pins and bushing but the shops here want 120 to put them in and the tools only 20.

HCO4x4

ok , got them today. took explaining to a lot of people but i got it done. thanks for the help!

HCO4x4

haha good idea. ill post how it goes. thanks!

HCO4x4

ok thanks a lot, mine have been broken since i got the truck. the tailgate is a little bent from dropping so low do you think theyll replace it?

S-10CREWCAB.NET

Search found 163 matches

Hydrogen Generator

Motor Mounts

Leaf over

4x4 not working correctly

Gabriel Max Control shocks